The front panel lights show you the status of the DIVA LAN ISDN Modem.
B1, B2
Indicates the status of the B-channels.
State Description
Green Indicates a data call
Orange Indicates a phone call
Off No call activity on the specified B-channel
Flashing An incoming or outgoing call is being established on the B-channel
Steady A call is connected and the channel is in use
D
Indicates the status of the ISDN D-channel.
State Description
Off The ISDN physical interface is not active. The LINK light may
provide additional information.
Flashing Indicates that the ISDN physical interface is initializing.
Flashing stops when initialization is complete. Continuous flashing
indicates an error in the initialization process (usually due to
incorrectly entered SPIDs). Data transmission may not be possible
on the D- or B-channels until the problem is resolved. The console
port can be used to further diagnose the problem. If you are using
AO/DI, continuous flashing indicates that the DIVA LAN ISDN Modem
cannot establish the X.25 data link layer on the D-channel.
Steady The ISDN physical interface has been initialized and is ready to
place or receive calls on the D- and B-channels.
LINK
Indicates the status of the ISDN physical interface.
State Description
Off The ISDN physical interface is not synchronized, or is improperly
connected. Check your ISDN cable.
Flashing The ISDN physical interface is synchronizing. Continuous flashing
indicates a problem with the ISDN line: Make sure that the line is
plugged in and that you are using the correct interface (S/T or U).
Check your termination requirements. (Page 161 of instruction
manual, hopefully the member still has it).
Steady The ISDN physical interface is active. Lights D, B1, and B2 may
provide additional status information.
E1, E2, E3, E4
Indicates the status of the four ETHERNET ports.
State Description
Off There is no device connected to the specified ETHERNET port, or the
connected device is not powered on.
Flashing Data is being received on the specified ETHERNET port.
Steady There is a device connected to the specified ETHERNET port and the
link is up.
Eicon DIVA LAN ISDN Modem indicator lights
/C
Indicates the status of Ethernet collisions in red.
State Description
Off No collisions
Flashing Indicates that an Ethernet collision has occurred because two
Ethernet devices connected to the DIVA LAN ISDN Modem are trying to
transmit at the same time. This is a normal occurrence and will
automatically resolve itself.
Steady Indicates that one of the Ethernet ports has encountered too many
physical layer errors to continue normal operation. The device
connected to this port will not be able to send or receive data.
Reset the port by temporarily unplugging the cable connected to it.
FAULT
State Description
Off The modem is operating normally.
Flashing A hardware fault has occurred. Contact your Eicon Technology
representative.
Steady A software fault has occurred. Contact your Eicon Technology
representative.
POWER
State Description
Off The unit is off. (Doh!)
Steady The unit is on. (Double Doh!)